Deformation Conference Program 2009
Deformation Measurement in Material, Component Testing and 3D Motion Analysis
May 25, 2009
12:00h Welcome Snack
13:00h Lectures
LFT Erlangen, Germany
Biasutti, Kuppert, Merklein
Investigation of failure under shear-tension conditions with optical metrology
Salzgitter Mannesmann Forschung, Germany
Schneider
Validation of FE analysis in forming applications - A numerical comparison between simulation and experiment using ARGUS
GOM, Germany
Friebe, Klein, Erne
FEA comparison tool in ARAMIS and ARGUS
Hardware developments and new sensor generation
PONTOS state of the art
Hardware developments and new sensor generation
PONTOS state of the art
Coffee Break & Exhibition
TUM Klinikum rechts der Isar, Trauma Surgery Department, Germany
Döbele
Optical detection of interfragment movements in trauma surgery, Biomechanical research of a new screw system
DTU Mechanical Engineering and Risø DTU, Denmark
Berggreen
The operation and maintenance of ARAMIS soft- and hardware in university engineering education as a shared multi-department facility
University of Poznan, Poland
Smardzewski
Photogrammetric 3D measurement of furniture quality control
NASA Dryden, USA
Hudson
Aircraft structural measurements with ARAMIS and PONTOS
GOM, Germany
Sanow, Friebe
Real-Time Sensor
System combinations with TRITOP
System combinations with TRITOP
Break & Exhibition
19:00h Dinner
May 26, 2009
09:00h Lectures
Uni Groningen, Netherlands
Ocelik
In-situ strain observation during high power laser cladding
IPF Dresden, Germany
Uhlig, Spickenheuer
Optical measuring with ARAMIS of human abdominal distension for tissue engineering and of bionic optimised composite structures for FEA verification
TUM, Dept. of concrete structures, Germany
Finckh
Measurement of bond performance of reinforced concrete strengthened with CFRP-strips
Audi, Germany
Held, Schleich, Sindel
ARAMIS applications at Audi AG Neckarsulm - An overview from small to large
Coffee Break & Exhibition
Integration of GOM's optical metrology in the wind turbine industry
DTU Mechanical Engineering and Risø DTU, Denmark
Berggreen
Material and component testing in wind turbine development with ARAMIS
Zebicon, Denmark
Laursen
Inspection of blades and towers using ATOS and TRITOP
ITA, Poland
Radke
Mounting preparation for off-shore wind turbine installations with TRITOP
Risø DTU, Denmark
Schmidt Paulsen
Full scale wind turbine measurements with PONTOS
Trilion, USA
Schmidt
Did you say 100 microns or 100 microseconds?
Stretching the limits of your optical measurement capability
Stretching the limits of your optical measurement capability
13:00h Snack/End
